About four years ago we completely renovated our 1950 kitchen. I was so excited to finally have the white kitchen of my dreams. Excitement usually turns to stress when living through a renovation, and this was no exception. After more than a few hiccups, renovation was coming to an end and the salt white marble counters I had chosen were being installed.
My Problems with Marble
When I chose the marble slab, I told myself I wouldn’t mind resealing the marble every 6 months and I would be very careful to not leave anything acidic on it. Well, love story short, we weren’t a match. The marble easily stained and scratched and did not suit our family. Who knew onion juice or a bag of chips could cause so much damage?
But truthfully, these marble counters were doomed from the start because of a horrible installation job. Apparently, the fabricators/installers were not familiar with white marble and used the wrong glue. So, the seaming became large brown lines (that they tried to fix but made it worse), and then the edges of the counters started to resemble dried yolk where the glue was now yellowing. On top of that, where the marble met the corner of the sink it looked like someone had chewed Doublemint gum and stuck it in there to seal the two together. In real life, it didn’t look like a dream kitchen and, in retrospect, I should have demanded that they reinstall it. But, a long renovation (it took over 3 months) will wear you down, and I was a young mom with a toddler and a baby who just wanted to be done with the process and have my house back.
Quartz to the Rescue
So when Wilsonart reached out and asked if I would be interested in taking a look at their products, it felt somewhat like divine intervention. I didn’t want to get my hopes up because I had looked at quartz during the initial sourcing a few years ago and wasn’t impressed. Cue Regina George playing in my head, “Stop trying to make fetch happen, it’s not going to happen!”. I felt like quartz just wasn’t going to happen but I ordered a few of their samples so I could see it in person.
Choosing what you like is obviously subjective. Here is what I was looking for: something with very soft veining (as opposed to graphic lines), not a lot of movement and no graininess (little dots that almost look pixilated). Arktos and Marrara (a close lookalike to Carrara Marble) were clear winners for me. I felt like I finally found a quartz that looked like natural stone! I could have easily gone with either one, but in the end chose Arktos because I liked the added white veining I saw in the sample.
Fabrication and Installation
How simple was swapping kitchen countertops? The process was surprisingly smooth. They chipped away at the old marble until it came off in chunks and then replaced the plywood underneath that had been damaged during demo. All the cabinets remained intact! Even the backsplash remained untouched during demo, but they later had to remove the bottom row of tile to make room for the quartz to slide in. We did have to replace the sink (which I had already been warned about), since the enamel was slightly scuffed up during the countertop removal.
They laid the quartz on top of the plywood, did several adjustments to make sure it was level, and then glued the quartz to the plywood. Getting the seams (where the two fabricated slabs meet) to look seamless took some finesse, and I am simply amazed at the new seams. They are barely there lines! And now there is such a smooth transition where the counter meets the sink.
I am beyond thrilled to join the quartz club. I know it will be a better fit for our family and I am already seeing my stress levels go down when we cook and eat (the kids have already spilled marinara sauce and defrosted blueberries on them and it wiped up like a dream!).
If you have any questions, please feel free to leave them in the comments and I will respond!
This was a paid partnership with Wilsonart but all writing and opinions are my own.